Advantages:
- Better quality of the product:
because of the absolute precision of die closing, the surface of the cores is always
extremely solid and homogeneous
- Reduced consumption, because less pressure in the process of resin injection is needed
(low pressure casting)
- Reduced machine shop rejection, and this means very good yield and appreciable savings
- Better productivity, because of the extreme decrease of revision time and machine stops
- Immediate operativeness. A particular hook system of the injection header assures to
easily and quickly carry out this operation
- It is extremely easy to use. Elmac has been designed for an easy and right use even for
not skilled staff.
|
Assembly
Elmac is hard-wired and supplied with control board and commands on board, so that it can
work immediately after connecting it to electricity. In the mechanical part, a system of
plugs and screws guarantees the precision of alignment even if it has to be disassembled
for maintenance. Controls on closing parallelisms are scheduled. |
| Technical features: |
F1 |
F2 |
| Injection |
Kg. 3.5 |
Kg 7.5 |
| Injection Capacity |
l 2.5 |
l 5.0 |
| Maximum Core Box Dimension |
|
|
| Width |
mm 450 |
mm 600 |
| Height |
mm300 |
mm 350 |
| Hydraulic Pressure |
atm 150 |
atm 150 |
| Hydraulic Control Unit |
KW 4 |
KW 4 |
| Air Pressure |
atm 6 |
atm 6 |
| Air Consumption |
Nm3/min 0.5 |
Nm3/min 0.8 |
| Load-less Cycle Time |
sec 10 |
sec 12 |
| Total Machine Weight |
Kg 1800 |
Kg 2500 |
| Machine Outside dimensions |
|
|
| Height |
mm 2400 |
mm 2500 |
| Width |
mm 4000 |
mm 4500 |
| Depth |
mm 1500 |
mm 1800 |
|
Plate Heating
Electrical with kW 5 F1/6 F2
On / off temperature with an independent heat regulator on each plate. |
| Pre-heating time
around 40’ to reach 350°, hydraulic die closing force 3000 kg. |
